Back to Contents Page

Coin-Cell Battery

Dell™ Inspiron™ N7010 Service Manual

  Removing the Coin-Cell Battery

  Replacing the Coin-Cell Battery

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not covered by your warranty.

CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on your computer).

CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the computer.

Removing the Coin-Cell Battery

1. Follow the instructions in Before You Begin.
   
   
2. Remove the battery (see Removing the Battery).
   
   
3. Remove the module cover (see Removing the Module Cover).
   
   
4. Follow the instructions from step 4 to step 6 in Removing the Hard Drive.
   
   
5. Remove the optical drive (see Removing the Optical Drive).
   
   
6. Remove the keyboard (see Removing the Keyboard).
   
   
7. Remove the palm rest (see Removing the Palm Rest).
   
   
8. Use a plastic scribe to pry the coin-cell battery out of the slot on the system board.
   
   

1

plastic scribe

2

coin-cell battery

Replacing the Coin-Cell Battery

1. Follow the instructions in Before You Begin.
   
   
2. Hold the coin-cell battery with the positive side facing up.
   
   
3. Slide the coin-cell battery into the slot and gently press until it snaps into place.
   
   
4. Replace the palm rest (see Replacing the Palm Rest).
   
   
5. Replace the keyboard (see Replacing the Keyboard).
   
   
6. Replace the optical drive (see Replacing the Optical Drive).
   
   
7. Follow the instructions from step 5 to step 7 in Replacing the Hard Drive.
   
   
8. Replace the module cover (see Replacing the Module Cover).
   
   
9. Replace the battery (see Replacing the Battery).
   
   

CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in damage to the computer.

Back to Contents Page